Reported 08/19/2020 12:00 AM
Project Title

IDIQ Contract for A-E Services for Architectural and Engineering Work for Oil Management, Waste/Hazardous Material

Physical Address View project details and contacts
City, State (County) State-Wide: AL, AZ, CO, CT, DC, DE, FL, GA, IL, IN, KY, MA, MD, ME, MI, NC, NH, NJ, NM, NY, OH, PA, PR, RI, SC, TN, TX, UT, VA, VI, VT, WV
Category(s) Professional Services
Sub-Category(s) Architectural, Engineering
Contracting Method Competitive Bids.
Project Status Accepting Qualifications
Bids Due View project details and contacts
Estimated Value Less than $75,000,000
Plans Available from Federal Agency
Owner View project details and contacts
Architect View project details and contacts

The intent of this contract is to provide comprehensive Architectural-Engineering (A-E) services to various Navy and other Department of Defense (DOD) installations / organizations world- wide in order to meet statutory compliance requirements for all applicable Final Governing Standards (FGS), DOD, Federal, State, local, and installation specific environmental laws, regulations, and guidance pertaining to the major work categories listed below. This support includes preparation of studies, plans, specifications, design documents, reports, cost estimates and all associated engineering work including but not limited to work in the following major categories: Primary Tasks: - Petroleum Storage Tank (PST) and Assets Compliance - Oil Spill Preparedness and Planning Compliance - Waste/Hazardous Material Management Compliance Additional Tasks: - PCB/Radon/Lead Based Paint (LBP) and Asbestos Management - Safe Drinking Water Act (SDWA) and Clean Water Act Compliance - Laboratory Work - Pesticide Management - Environmental Condition of Property Programs - Sustainability Work - Air Quality and Clean Air Act (CAA) Compliance - Environmental Management System (EMS) and Compliance Auditing Support - Miscellaneous Tasking Work may include minor incidental system modifications and calibrations at various facilities associated with individual task order work in order to assure compliance and allow for certification and/or testing. Examples of such minor incidental system modifications might include such things as installing a high point vent in a fuel pipe to allow for leak testing, installing a temporary blind flange in a fuel pipe to allow for leak testing a system, repairing an air filter door and replacing an air filter to allow for air emission certification of an incinerator, minor repair of an existing Back-Flow Prevention (BFP) device to allow for proper operation and certification, or other similar modifications.


Bidder's List View project details and contacts
Prospective Bidders View project details and contacts
Project Documents
 Engineered Spec Sheet
 Architectural Plans
 Other Documents