Electrical Power Upgrade for New Laboratory Equipment

This project is to provide power supply to new laboratory equipment based on the electrical power study on existing electrical panelboards inside the Laboratory. The electrical power study for existing electrical system for this laboratory had been completed and report had been submitted and approved for this construction project. Scope of work includes but is not limited to the following: o Disconnect and remove existing panelboards 'CL1-D3' and 'CL1-D3B'. o Provide new 120/208V, 3 Phase, 4 Wire, 84 pole panelboards 'CL1-D4'. o Provide new receptacles and branch circuit wirings for new laboratory equipment. o Provide new branch circuit wiring to existing wiremold/receptacles fed from removing panelboard 'CL1-D3'. o All field work shall be performed on and off-hours without disturbing existing equipment in active 24/7 operation of the Lab. Lab operations are not to be interrupted during field work. o Contractor shall carefully coordinate with Laboratory Manager any scheduled/approved circuit outages in advance of any work that would affect Lab operations. o Provide all necessary tools, equipment, and Personal Protective Equipment (PPE) to perform the work safely, effectively, and timely. Tools, equipment, and PPE shall comply with the requirements of OSHA Standard 29 CFR 1910, Subpart I, VA Safety Requirement and NFPA 70E.

Division 26 -

Electrical.