Design Build-Step 1-Golden Gate Pkwy over Santa Barbara Canal Bridge Replacement

Project is to remove the existing roadway bridge carrying Golden Gate Parkway (CR886) over Santa Barbara Canal and to remove and transport (for re-use) the two (2) existing steel pedestrian bridges carrying the sidewalks over the Canal with a new bridge that will carry both roadway traffic (2 lanes each direction) and (2) sidewalks (1 each direction) across the canal. The transverse section for the new bridge shall be designed to accommodate two (2), 12-foot travel lanes (in each direction), an approximate eight-foot wide outside shoulder and a 12-foot wide sidewalk on each side. A 1’-4” median concrete barrier shall be installed at the median to separate the two-directional traffic. Similarly, 36-inch high concrete traffic railings shall be installed to separate the sidewalks and the traffic lanes.

Division 01 -	General Requirements, Vehicular Access and Parking, Traffic Control, Temporary Barriers and Enclosures.
Division 03 -	Concrete, Concrete Reinforcing, Precast Structural Concrete.
Division 05 -	Metals, Structural Steel Framing, Structural Steel for Bridges, Steel Joist Framing, Steel Joist Girder Framing.
Division 07 -	Thermal and Moisture Protection, Expansion Control.
Division 09 -	Finishes, High-Performance Coatings.
Division 10 -	Specialties, Signage, Traffic Signage.
Division 26 -	Electrical, Exterior Lighting, Lighting Poles and Standards, Roadway Lighting.
Division 31 -	Earthwork, Embankments, Erosion and Sedimentation Controls, Slope Protection, Gabions, Riprap, Special Foundations and Load-Bearing Elements, Driven Piles.
Division 32 -	Exterior Improvements, Bases, Ballasts, and Paving, Flexible Paving, Rigid Paving, Fences and Gates, Retaining Walls.
Division 34 -	Transportation, Bridges.