Replace the EPDM Roof Membrane

1. Remove existing EPDM membrane roof from the entire perimeter of the building. 2. Inspect existing insulation and remove/replace any wet or damaged areas. 3. Lift bottom course of metal shingles for installation of new membrane roofing to be installed. 4. Install a new 1/4” primed cover board over existing insulation. 5. Adhere new FiberTite (or equal) membrane roofing over the cover board. 6. Terminate the flashings and heat weld seams to ensure a water tight seal on the roof. 7. Fabricate and install a slip metal to go under the first course of metal shingles around the entire perimeter of the roof area. 8. Remove and dispose of all waste and debris associated with work on a daily basis. Removal from the site shall be at contractor’s expense. 9. New roofing material shall have a minimum 20 year manufacturer’s warranty and one year labor warranty. 10. Patch metal shingle roof in 2 area where HVAC vent stacks were re- moved from roof. 11. Replace existing exposed/rusted fasteners as needed on ridges in metal shingle roof. (Approximately 20)

Division 07 -

Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.