Replace Medium-Voltage FPL Cable , Conduit, and Brackets on Bridge 875101

Repair would install a brand-new conduit made of PVC Schedule 80, with a 3.5” trade-size. The new conduit would be supported by stainless steel brackets, installed at the bottom flange of the metal I-Girder. The spacing of the support brackets would be 5 Ft. FPL has been contacted about this situation and are waiting for the bridge owner/operator to install the new conduit and new 3-phase MV 7.2kv # 1/0 AWG cables. The existing cables have been stressed under the load of their own weight and therefore, calls for the entire 1,000 Ft run of cable to be replaced. Once accomplished, FPL will proceed with the re-splicing of the new cables into their system, at the Island’s FPL MV pull box. The proposed conduit system mounts on the metal I-Girder of the bridge, hence it does not require any drilling into the bridge’s concrete, which, built in 1950, may contain asbestos.

Bridge, New Construction.

Division 02 -	Existing Conditions, Demolition, Selective Demolition, Selective Interior Demolition.
Division 06 -	Wood, Plastics, and Composites, Rough Carpentry, Finish Carpentry.
Division 07 -	Thermal and Moisture Protection, Dampproofing and Waterproofing, Thermal Protection.
Division 08 -	Openings, Doors and Frames, Windows.
Division 09 -	Finishes, Plaster and Gypsum Board, Ceilings, Flooring, Painting and Coating.
Division 21 -	Fire Suppression.
Division 22 -	Plumbing.
Division 23 -	Heating, Ventilating, and Air Conditioning (HVAC), Instrumentation and Control for HVAC, HVAC Air Distribution.
Division 26 -	Electrical, Lighting.