2021 Roadway Paving Program

Milling and repaving of seven roads totaling approximately two miles. 1. Milling of bituminous asphalt to minimum 1½” inches full width, curb to curb. 2. Paving of Superpave Asphalt Mixture Design, HMA Wearing Course, PG 64-22, < 0.3 Million ESALS, 9.5 mm mix, 1½" depth, SRL-H, including leveling course and tack coat. 3. Re-establishing pavement markings in accordance with PennDOT Pub 408 (Construction Specifications) and Pub 111 (Pavement Parking and Signing Standards). The Contractor shall provide asphalt wedges or similar temporary protection to exposed manhole and drainage structure frames that will be left overnight. Paving on each road shall not commence until the Township has approved surface preparations (free of debris, clean and vertical interface at manhole and drainage structure frames, etc.) At curbed driveway entrances, provide a 0.75” reveal at curb to facilitate drainage along roadway edge. Adjust milling depth as necessary to accommodate paving with reveal.

Division 01 -	General Requirements, Vehicular Access and Parking, Traffic Control, Temporary Barriers and Enclosures.
Division 32 -	Exterior Improvements, Flexible Paving, Asphalt Paving, Rigid Paving, Concrete Paving, Paving Specialties, Pavement Markings.
Division 33 -	Utilities, Storm Drainage Utilities, Storm Drainage Structures.